| POLARITY
CHANGE |
These
two indicator lamps reverse every 2 minutes to show
that a polarity change has occurred at the electrodes |
| CONTINUITY |
This
lamp indicates that there is a complete circuit between
the control centre and the electrodes - flashes once
per second |
| CONDUCTIVITY |
This
lamp indicates that there is sufficient current flowing
for normal ionisation - only operates in upper range
of current settings |
| OVER
RANGE |
This
lamp is illuminated in the event of a short circuit
of the output terminals or the water conductivity
is too high. This may also occur if chemicals are
added to the pool via the skimmer, until flushed through
the filter. |
| FUNCTION
OF THE PROGRAMME & DISPLAY BUTTONS |
| |
Press
to revert to NORMAL display
after programme adjustment.
Automatically reverts after a few seconds. |
| |
TO
CHECK
the current setting press the CURRENT
SET button once.
The LED opposite one of
the current set positions will be illuminated.
TO CHANGE current set press
and hold down current set button until LED
begins to flash. Release and press repeatedly until
the desired current set position is indicated.
TO SET the new selected
current set press NORMAL DISPLAY.
CURRENT SET is normally
set on 100% unless a unit is shared between two systems
such as a pool and a spa for example. |
| |
TO
CHECK
the timer setting press the TIME
SET button once.
The LED opposite one of
the time positions will be illuminated. |
| |
TO
CHANGE
the timer setting press the TIME
SET button and hold pressed
until the LED begins flashing. Release and press
repeatedly until the LED next
to the desired time is illuminated in the timing cycle.
Continuous operation is indicated
by all LEDS flashing.
The select sequence is "CONTINUOUS" - "12
Hours" - "6 Hours"
- "3 Hours" - "1.5 Hours" - ".75
Hours" - "CONTINUOUS" etc.
To set the new time press NORMAL
DISPLAY |
Domestic
System
LED Readout of Current
